Pages

Sunday, June 21, 2009

How bout a few tips to tickle your fancy

There have been quite a few techniques shown lately so I decided to go with some tips I have learned over the last few years. Some you may already know about and some you may not…

Jammed Punches:
Try popping them in the freezer for a bit. Heat expands metal thus causing them to get jammed on occasion. By cooling the metal part of the punches they should then become “unstuck”.

Sharpening punches:

Tear you off a piece of aluminum foil( I use the heavy duty) and punch through the foil a few times (I usually punch through at least 10 times). That will sharpen your punches.

Stiff Punches:
Use wax paper that you have folder a few times to punch through. By doing this you will lubricate your punches if they are stiff.

Mixing Paint colors
Use a freebie CD (like the free aol cd’s you can get almost anywhere) and place on top of a glass of water to act as a paint pallet. You can use the hole in the top to drop your paint brush into for easy clean up. Wash the CD and reuse it again next time.

Ink Pads:
If you have dry ink pads you can turn them upside down and store them like that for a bit. This will allow the ink to seep through to the pad and you will be able to use every last bit of ink. I store all my ink pads upside down in a drawer at all times. The only ones you don’t have to do this with (that I know of) is Stampin Up’s pads because of how they close.

Metal Embossing:
Dry emboss on Foil Pie tins. You will get some fabulous results and the thickness is perfect. You can also run the tins through your cuttlebug with some of your embossing plates. Doing this the possibilities are endless with what you can create. Backgrounds to charms or embellishments anything you can think of can be done.

Tearing:

Tear paper or vellum towards you to open up the layers

Un-Mounted Stamps:

As you may know, un-mounted stamps come without a cushioned layer on the back of them. There are products called Kling-on or Ez-mount available to attach to the back of these stamps. As a low-cost alternative, lay a cheap spongey mouse mat under your card or paper before stamping, which will do the same job & allow a much crisper image when stamping

Sticking Pressed Flowers:
When sticking pressed flowers onto your card with a wet glue, it pays to put a little glue onto a flat surface and use tweezers to pick up the flower and dip it into the glue, then add it to your work, as it saves messy fingers and short tempers.

That is about all i can think of for now..but as i remember more i will come back with a part 2 at a later date..

2 comments:

  1. Those tips about the punches are *so* timely! Thanks!

    ReplyDelete
  2. welcome tina!
    glad that came at the right time ;)

    ReplyDelete